Run a Health Scan / Health Glance

Health Glance gives you a convenient way to check multiple supported wellness indicators from one place on your TG-Sense Ultra Smartwatch.

With a single scan, your watch collects supported sensor readings and creates a wellness summary.

When TG-Sense Ultra is connected to the G Band app, supported results can also synchronize with your smartphone.

Before Taking a Health Scan

Correct watch positioning is important for consistent sensor contact.

For the best experience:

  • Wear TG-Sense Ultra snugly on your wrist.
  • Do not wear the watch excessively loose.
  • Do not overtighten the strap.
  • Keep the rear sensor area clean.
  • Make sure the sensors are resting flat against your skin.
  • Remain still during the measurement.

Step 1 — Position Your Watch Correctly

Place TG-Sense Ultra securely on your wrist.

The rear sensor area should remain in continuous contact with your skin.

For more consistent measurements, wear the watch slightly above your wrist bone.

Step 2 — Open Health Glance

Open the app menu on your TG-Sense Ultra.

Locate:

Health Glance

Depending on your watch firmware, the exact icon or wording may vary slightly.

Step 3 — Start the Health Scan

Open Health Glance and tap the displayed:

Start

Measure

or equivalent measurement control.

Your TG-Sense Ultra will begin collecting the supported wellness readings.

Step 4 — Remain Still

Keep your arm relaxed and avoid unnecessary movement while the scan is running.

Do not:

  • Remove the watch
  • Lift it away from your skin
  • Move it around your wrist
  • Interrupt the measurement

Allow the scan to finish completely.

Step 5 — Review Your Health Glance Results

When the scan finishes, TG-Sense Ultra will display the available results from the completed wellness scan.

Supported information may vary depending on watch version, software, firmware, and enabled features.

Step 6 — Sync the Results With G Band

When your TG-Sense Ultra is connected to G Band, supported Health Glance information can synchronize with the app.

Open G Band on your phone and allow the watch a moment to sync.

This makes it easier to review supported wellness information and trends over time.

Tips for More Consistent Measurements

For repeat checks, try to use similar conditions each time.

Wear the Watch Consistently

Keep TG-Sense Ultra in approximately the same position on your wrist.

Keep the Sensors Clean

Dirt, sweat, lotion, or moisture between the sensors and your skin can affect sensor contact.

Wipe the rear sensor area gently when needed.

Remain Still

Movement during the scan can interfere with sensor readings.

Maintain Skin Contact

Make sure the rear of the watch remains flat against your wrist until the scan is complete.

Repeat if Necessary

If a reading appears unusual or the measurement is interrupted, reposition the watch and run the scan again.

Results Not Appearing in G Band?

Try the following:

  1. Make sure Bluetooth is turned on.
  2. Open the G Band app.
  3. Confirm TG-Sense Ultra shows as connected.
  4. Keep your watch close to your smartphone.
  5. Allow a few moments for synchronization.
  6. Close and reopen G Band if necessary.

Health Glance vs. Individual Measurements

Health Glance provides a convenient way to check multiple supported wellness indicators together.

You can also access individual health functions separately from the watch menu when you want to check a specific supported metric.

Available health functions can vary depending on your TG-Sense Ultra version and firmware.

Important Wellness Notice

TG-Sense Ultra is a consumer wellness device and is not a medical device.

Health measurements, estimates, scores, trends, and reports provided by TG-Sense Ultra or the G Band app are intended for general wellness and informational purposes only.

They are not intended to:

  • Diagnose a disease or medical condition
  • Treat a medical condition
  • Cure a disease
  • Prevent a disease
  • Replace professional medical testing
  • Replace medical equipment
  • Replace advice from a qualified healthcare professional

If you have symptoms, a medical concern, or an unexpected health reading, consult an appropriately qualified healthcare professional.

Need Assistance?

Need help using Health Glance or syncing your wellness information?

Our TechGlobe support team is ready to help.

support@techglobe.us

TechGlobe | TG-Sense Ultra Support